Velocity Stacks, Standard Height , fits 36-40mm DRLA & IDF
€7.801 5/8″ tall
Die cast velocity stacks help eliminate mid-range flat spots, improve throttle response and increase top end power. A complete selection is available to fit Weber IDF and Dellorto DRLA and DHLA carburetors.
Sold Individually.
Weber style 40/44
Cross Linkage Arm 3400
€8.133400 Linkage Arm – fits L/R side DRLA, IDF & FRD Type-1, 2 & 4
Each –2 required in twing carb setup
WEBER IDF etc X linkage operating arm
Cross Bar Linkage Kit, Weber, IDF used
€50.00We’ve made it easy to clean up your throttle linkage act. This kit includes all those hard to locate goodies with one part number. Each Link Pak includes; two cast linkage arms (L/R), one center throttle cable arm, two Hex Shaft support bolts, four heim joints (L/R hand threads), two threaded linkage rods, jam nuts, two centering springs, one barrel clamp, and two steel carburetor linkage arms.
Note: Hex Cross Bars are sold separately if required
all parts available separately from stock as well
Jet Doctor Kit – Weber IDF (one carb)
€29.64Plugged Idle Jets can result from dirt, and other debris getting into the carburetor, and pooling up in the top of the carburetor cover.
On this cover, there are two small holes that are used to take in extra air, in addition to the air that is sucked in through the velocity stacks. When excess debris gets through these holes, it ends up clogging the idle jets.
The Weber Jet Doctor blocks these holes, and provides a ‘snorkel’ to breathe fresh air from about an inch and half above the top of the carburetor cover, thus eliminating the ability for the debris to seep into carburetor’s idle jets.
An O-Ring gasket also provides a tight seal, to make certain that no debris can get inside the idle jets, and ruin your day.
Venturi Dell DRLA – Main Venturi
€14.76Please let us know required size.
Sizes: 28, 30, 32, 34, 36, 38
Contact us for more info.
36 mm in stock
Gasket Weber Carb Base 2700
€5.85Weber Carb Base Gaskets – 36-40mm DRLA and 40 IDF
Each.
Made In USA